Maiden flight of Minotaur I Thelma, Louise, JAK, and STENSAT failed to contact ground after deployment from OPAL Thelma & Louise deployed on 12 February, JAK & STENSAT on 11 February Picosats also deployed from OPAL at 03:34 UTC on 7 February
Tested a leak sealant and inspected a malfunctioning solar panel on Kvant-1. A final photographic record of the outer surfaces of Mir was made during a panorama-inspection.[32]
Inspected and secured the Orbital Replacement Unit Transfer Device, completed assembly of Strela cargo crane, and replaced one of Unity's two early communication antennas.[18]
Attached cabling that integrated the Zvezda module fully to the rest of the ISS, and constructed and attached a magnetometer that serves as a backup navigation system for the station.[24]
Connected two sets of cables to provide power to heaters and conduits located on the Z1 truss, relocated two communication antenna assemblies, and installed a toolbox for use during future on-orbit construction.[27]
Installed the PMA-3 docking port, and prepared the Z1 truss for the installation of the solar arrays.[27]
17 October 14:30
6 hours 48 minutes
21:18
STS-92 ISS Discovery
Leroy Chiao William S. McArthur
Installed two DC-to-DC converter units atop the Z1 truss.[27]
18 October 15:00
6 hours 56 minutes
21:56
STS-92 ISS Discovery
Michael Lopez-Alegria Peter Wisoff
Removed a grapple fixture on the Z1 truss, deployed a Z1 utility tray, Manual Berthing Mechanism latches for Z1 were cycled and opened, and demonstrated the SAFER pack's abilities.[27]
Attached the P6 truss to the Z1 Truss, and prepared the solar arrays and radiator for deployment.[29]
5 December 17:21
6 hours 37 minutes
23:58
STS-97 ISS Endeavour
Joseph R. Tanner Carlos I. Noriega
Configured the space station to use power from P6. Positioned the S-band antenna for use by the space station. Prepared the station for the arrival of Destiny.[29]
7 December 16:13
5 hours 10 minutes
21:23
STS-97 ISS Endeavour
Joseph R. Tanner Carlos I. Noriega
Positioned a floating potential probe to measure the plasma field surrounding the space station, performed repair work to increase tension in the starboard solar array blankets that did not stretch out completely during deployment, and installed a centerline camera cable outside the Unity node.[29]
Launches are separated by dots ( • ), payloads by commas ( , ), multiple names for the same satellite by slashes ( / ). Crewed flights are underlined. Launch failures are marked with the † sign. Payloads deployed from other spacecraft are (enclosed in parentheses).