Helio Courier H-295 on floats, Lake Hood Seaplane Base, Anchorage, AK
The Helio Courier is a cantilever high-wing light STOLutility aircraft designed in 1949.
Around 500 of these aircraft were manufactured in Pittsburg, Kansas, from 1954 until 1974 by the Helio Aircraft Company. The design featured four leading edge slats that deployed automatically, and large trailing edge flaps. The engine was the 295 hp Lycoming GO-480, which had a gearbox that lowered the output RPM and allowed for the use of a large three-bladed propeller to further improve takeoff performance. Couriers were famous for their takeoffs, which often took only a few plane lengths and then climbed at very high angles. During airshow demonstrations, it was common for the aircraft to actually take off across a 100 - 200 foot wide runway.
During the early 1980s, new owners (Helio Aircraft Ltd.) made an attempt to build new aircraft with direct-drive Lycoming engines, to replace troublesome and expensive geared engines. In a further effort to reduce weight, a new composite landing gear was featured. The new models also featured modest winglets. Two models were produced, the H-800 and H-700. A total of 18 aircraft were built. The rights to the Helio Stallion and Helio Courier were acquired by Helio Aircraft of Prescott, Arizona.[1]
The demonstrator for the Courier's concept, "Helioplane #1", was converted by the then-local Wiggins Airways firm from a Piper PA-17 Vagabond Trainer, one of the so-named "short-wing Pipers" in production following World War II. Only the cabin area of the PA-17's original airframe remained unmodified, with the fuselage lengthened by four feet (1.2 meters), given a taller fin-rudder unit, clipped the Vagabond's stock 29 ft-3 inch (8.92 meter) wingspan down to only some 28.5 feet (8.7 meters), fitted the shortened wings with full-span leading-edge slats, long-span wing flaps that forced the ailerons to be much diminished in their span - only occupying the two outermost rib bays inboard of the wingtip; and a longer-travel main landing gear of a taller design, not unlike that of the 1930s-origin Fieseler Fi 156 German military short take-off and landing (STOL) pioneer aircraft. The powerplant for the demonstrator was switched to the Continental C85boxer-four cylinder air-cooled engine, upgraded with fuel-injection, and uniquely equipped with a multi-belt speed reduction unit to drive its Aeroproducts nine-foot (2.75 meter) diameter, variable-pitch two-blade propeller, which contributed greatly to the amazing STOL flight characteristics of the demonstrator aircraft.[3][4] The demonstrator's first flight took place on April 8, 1949, flying from what was then called the Boston Metropolitan Airport.[5]
For the construction of the production Courier aircraft, its all aluminum-clad airframe features a welded 15G steel-tube center section fuselage, with shoulder harnesses that protect the occupants in an emergency. The wings are of conventional aluminum construction, but feature Handley Pageleading-edge slats that deploy automatically when the aircraft's airspeed falls below a certain value — 55 to 60 miles per hour (89 to 97 km/h). The slats contribute to the Helio's outstanding short takeoff and landing capability, and allow for stall/spin-proof controllable flight. In conjunction with the leading-edge slats, 74% of the trailing edge incorporates high-lift slotted flaps, which together with interrupter blades atop each wing when roll control is lost at very low airspeed, allows for a tight turning radius. The Helio Courier could maintain control at speeds as low as 27 miles per hour (43 km/h).[6]
The design of the Helio features a large vertical tail surface and rudder for control at very low flight speeds. However, on conventional geared aircraft (taildraggers), the airplane tends to be sensitive to crosswinds, thus a crosswind gear option is available, allowing the main tires to caster left or right 20 degrees, increasing the crosswind component to 25 miles per hour (40 km/h). The Helio has its main gear placement far forward of the cabin, enabling hard braking on unprepared landing areas. A tricycle-gear model was produced, but is unsuitable for unprepared rough terrain.
Helios are also capable of being equipped with floats; both straight and amphibious floats being offered.
With a minimum-control speed of around 28 mph, the Courier is perfectly suited for confined off-airport operations. The first one was certified in July 1954 and powered by the 260 hp Lycoming GO-435-C2B2. The first production Courier (Serial Number 001, dubbed "Ol' Number 1")C-G001 was previously owned and operated by JAARS as N242B until 2010.[7] Jaars Helio Courier has been a frequent airshow performer at EAA AirVenture Oshkosh for decades, displaying its slow flight capability in front of thousands and serving as a drop plane for the Liberty Parachute Team.[8]
In 1957, a "Strato Courier" set an altitude record over Mexico City, Mexico at 31,200 ft powered by a geared Lycoming GSO-480-A1A5 (340 hp), only one was built. The Super Courier, a more powerful derivative, was used by the U.S. Air Force from 1958 onward, by the U.S. Army Special Forces in the 1960s and 1970s and by Air America during the Vietnam War as the U-10. In U.S. Army and Air Force service, the U-10 Super Courier was used for liaison work, light cargo and supply drops, psychological warfare, forward air control (Air Force), insertion and extraction by land and sea (Army), and reconnaissance. Various versions were produced up through the 1980s, including turbine-powered variants.
The Super Courier saw military service in the United States as the U-10 (ex L-28). Over 120 were built: The L-28A (2, later redesignated U-10A), U-10A (26), U-10B extended range and paratrooper doors (57), and the U-10D with a higher gross weight(36). There was no U-10C.
Helios remain very popular among bush pilots in Canada (32 current) and Alaska and missionaries who fly into rough, relatively unprepared jungle airstrips because of its superior STOL abilities. Some operators use the Helio Couriers for aerial observation. Both Winged Vision Inc. of Gaithersburg, Maryland and the Pima County, Arizona, Sheriff's Department each operate two of the rare tri-gear model and mount gyro-stabilized cameras under the wing for aerial observation.[9] Pima County mounts a FLIR camera for law enforcement, and Winged Vision mounts a high definition television camera for coverage of major sports events.[10]
^Peterson, Norm. "There's a Ford in your Future." Sport Aviation, August 1991.
^ ab"Smithsonian National Air & Space Museum - Collections - Helioplane - Long Description". airandspace.si.edu. National Air & Space Museum. Archived from the original on December 28, 2016. Retrieved December 27, 2016. Professor Koppen was not a newcomer to the so-called affordable safe light plane design field as he was the designer of Ford's 1925 Flivver Plane and designed the pre-World War II two-control, spin proof General Skyfarer airplane. The professors tried several sources for financial support in government, academia, and industry for the experimental project but eventually they put up their own money. They arranged for Greater Boston Metropolitan Airport fixed base operator, E.W. Wiggins Airways and volunteers to convert a Piper PA-17 Vagabond to the two-place Helio No.1, and, in the end, the investment of the professors was about $6,000. The only unmodified part of the Vagabond was the fuselage cabin area. The original 65 hp Continental engine was replaced with a fuel-injected 85 hp Continental fitted with a multi-belt reduction unit that drove a specially designed nine-foot Koppers Aeromatic propeller. This extra large diameter propeller with its large thrust component was a major contributor to the success of the Helio-1. The propeller's wide slipstream coverage of the wing slats and slotted flaps provided a substantial added lift component during the take-off, landing and the slow/near hover flight regimes. The large propeller size dictated a higher-than-normal main landing gear with long throw shock struts to achieve sufficient propeller ground clearance...The fuselage was lengthened by nearly four feet and the Vagabond's already short 29-foot 3-inch wing was shortened by another nine inches. The wing had a complete array of the high lift devices available at that time, including leading edges with retractable full span Handley Page automatic slats and trailing edges with the equivalent of full-span slotted flaps. The ailerons could be drooped in the slow speed configuration to act as flaps and still perform for banking purposes. In addition to these devices, a later development called a lateral roll control augmenter was installed at the wing leading slat gaps. This device was aerodynamically positioned at the slat gap so that it provided excellent slow speed roll stabilization.